What to check before and after corn thresher operation
1. Check that all parts are in good condition, and the fault should be eliminated in time. Check the tightening of the bolts in all parts, and tighten them if they are loose.
2. Remove the residual grain and debris after the previous operation, conduct a comprehensive inspection of the machine, and lubricating oil should be added to each rotating part such as bearings.
https://cornmachines.com/sweet-corn-thresher-machine/
Inspection after operation:
1. After each shift of the corn thresher, check the bolt tightening of each part and maintain the machine. After the operation is completed every quarter, a comprehensive inspection should be performed. If any damaged or worn parts are repaired or replaced in time, to ensure the next threshing season.
2. After maintenance and repair, clean the inside and outside of the machine and place it in a dry and ventilated room. The machine should not be placed directly on the ground to prevent moisture. If the paint comes off, it should be re-brushed, and the unpainted parts should be coated with anti-rust oil.
Professional introduction and principle analysis of corn thresher
It mainly includes a body, the body has a feeding port, the electric seat is connected to the body, the motor is installed on the power base, the drive shaft is installed on the bearing base, the drive shaft is connected to the motor through a belt, and the drive shaft is provided with a spiral bar And rubber nails, transmission shaft through gear and multi-band matching transmission shaft, convex rubber wheels on the transmission shaft.
Both ends of the bearing seat of the corn thresher drive shaft are not on the same horizontal plane. The driving shaft is provided with a spiral bar and a rubber nail. The driving shaft is provided with a plurality of rubber wheels. The driving shaft and the driving shaft are separated from each other and can be evenly entered into the ear device. The relative rotation between the two peeling shafts is distributed. In the condition of ear rotation, it was pushed forward smoothly. In March, it was a peeling claw to tear open the leaf, and in a moment, the shaft was forged the bracts of the press, and the peeling was completed. 0.85 ~ 12500 / H efficiency, stripping rate 80% ~ 95%, less than 1% broken rate, loss rate is less than 2%. The complete corn peeling operation is used instead of manual operation to improve work efficiency.
